1.3m Electric shearing/ cutting machine

Electric shearing machine:
Electric Shearing Machine is mainly used for cutting irregular planar graph, in theory, as long as can be drawn using AUTOCAD graphics can be cut ( a radius of less than 2 times the width of the plasma Slotted graphics can not be cut) .
To use electric shears:
Electric shears that may arise in the course of the following situations
Shearing machines starting to idle a number of cycles to ensure that under normal circumstances, try cutting different thickness of sheet metal, from thin to thick. Performance to ensure that users are familiar with shears.
Shear test must be of different thickness when adjusted for different blade gap. If the corresponding blade gap adjustment, then the impact of blade durability. 3 shears to open in the shear gauge switch, observe the oil line pressure value, shear stress should be less than 12mm boards 20MPa. This remote relief valve No9, factory pressure settings 20-22MPa, the user must comply with this requirement shall not require that the material surface to improve super-shear stress, resulting in damage to the machine.
Operation, the sound balance. Shears, if noise should stop checking. 5 Shearing operation, the fuel tank to improve the temperature " when you shut down a break of more than 60 degrees.
Shears maintenance method:
1, to operate in strict accordance with operating procedures.
2, each pre-boot requirements according to lubrication chart from time to time, on-site, quantitative lubricating oil should be clean without precipitation.
3, machine tools must always be kept clean, no part of the anti-rust oil paint.
4, the motor bearing lubrication oil ripples add the word to be changed regularly, and frequently check the electrical part of the work is properly secure.
5, periodic inspection triangle belt, handles, knobs, buttons for damage, wear a serious change in time and report additional spare parts.
6, regular inspection repair switches, insurance, handles, ensure its reliable operation.
7, day 10 minutes before work on the machine tool lubrication and scrub clean machine.
8, is strictly prohibited non-designated personnel to operate the equipment, it is something people must do away from the machine stopped.